Assembly; Operation - Husqvarna 129C Manuel D'utilisation

WARNING:
before you assemble the product.
To attach the loop handle
1. Attach the loop handle to the shaft in compliance
with the illustration and tighten. (Fig. 25)
2. Make sure that the loop handle attaches between
the arrows on the shaft.
To assemble the two-piece shaft
1. Turn the knob to loosen the shaft coupling. (Fig. 26)
2. Align the tab of the shaft (A) with the arrow on the
shaft coupling (B). (Fig. 27)
3. Push the shaft into the shaft coupling until the shaft
attaches. (Fig. 28)
4. Make sure that you tighten the knob before you use
the product. (Fig. 29)
To disassemble the two-piece shaft
1. Turn the knob to loosen the shaft coupling. (Fig. 30)
2. Push and hold the button (C). (Fig. 31) Hold the
engine end and pull the shaft out of the shaft
coupling.
WARNING:
safety chapter before you operate the
product.
Fuel
To use fuel
CAUTION:
cycle engine. Use a mixture of gasoline and
two-cycle engine oil. Make sure to use the
correct quantity of oil in the mixture.
Incorrect ratio of gasoline and oil can cause
damage to the engine.
Gasoline
CAUTION:
octane number less than 90 RON (87 AKI).
This can cause damage to the product.
155 - 008 - 24.08.2021

ASSEMBLY

Read the safety chapter

OPERATION

Read and understand the
This product has a two-
Do not use gasoline with an
To assemble the cutting attachment
To attach the cutting attachment guard and
the trimmer head (straight shaft)
1. Attach the cutting attachment guard (A) to the shaft
with the bolt (L). (Fig. 32) Make sure to use the
correct cutting attachment guard and the correct
trimmer head.
2. Attach the drive disc (B) to the output shaft.
3. Turn the output shaft until the hole in the drive disc
aligns with the hole in the gear housing.
4. Put a small screwdriver (C) in the hole to lock the
shaft. (Fig. 32)
5. Turn the trimmer head (H) counterclockwise to
tighten the trimmer head to the gearbox. (Left hand
threads.) (Fig. 33)
To attach the cutting attachment guard and
trimmer head (curved shaft)
1. Attach the guard. (Fig. 34) Tighten the nut.
2. Attach the dust cup on the shaft. (Fig. 35)
3. Hold the dust cup with an adjustable wrench to make
sure the shaft does not turn.
4. Attach the trimmer head to the shaft. Turn the
trimmer head clockwise.
CAUTION:
more than 10% ethanol concentration (E10).
This can cause damage to the product.
• Always use new unleaded gasoline with a minimum
octane number of 90 RON (87 AKI) and with less
than 10% ethanol concentration (E10).
• Use gasoline with a higher octane number if you
frequently use the product at continuously high
engine speed.
Two-cycle engine oil
• Use only high quality two-cycle engine oil. Use only
an air cooled engine oil.
• Do not use other types of oil.
• Mixture ratio 50:1 (2%)
Gasoline
1 U.S. Gal.
1 UK Gal.
5 l
Do not use gasoline with
Oil
77 ml (2,6 oz)
95 ml (3,2 oz)
100 ml (3,4 oz)
9