Turn Wheelchair On/Off; Sleep Mode; Using The Battery Charge Indicator - Vermeiren LiNX 200 Mode D'emploi

The hazard warning lights, used in critical situations, can be switched on or off by short pressing the
"Hazard warning lights" (9) button.
To brake while driving, simply push the joystick to its central position. Move the joystick slowly for
gradual braking. Simply release the lever for a quick stop; the wheelchair will then stop as quickly as
possible.

Turn wheelchair On/Off

Turn the power on:
Press the On/Off button. The On/Off button will light green and all LED's of the
battery indicator turn on and display the current battery status.
If there is a fault with the system when powering up, the status indicator will indicate the fault with
a series of red flashes. If the fault is one that prevents the system from driving, then the battery
gauge will flash continuously.
If the wheelchair is turned on while the joystick is out of neutral, the wheelchair will not drive.
Release the joystick back to neutral in 5 seconds and the fault will disappear. If the joystick is not
released back to neutral (centre) within 5 seconds, the fault becomes a Module fault (the status
indicator is flashing red), and the wheelchair will not drive. To clear this fault, loosen the joystick
to the neutral position and turn the operator control off and then back on.
Turn the power off:
Press the On/Off button. The system will power down and the status indicator
will switch off.
Emergency stop:
If the user needs to stop the wheelchair quickly, or stop a seating motion quickly, the On/Off
button can be pressed to perform an EMERGENCY STOP. The wheelchair will come to a halt
quickly.

Sleep mode

The operator control will go to sleep after a period of inactivity of a quarter.
When the system sleeps, it is partially turned off to reduce energy consumption.
To reactivate the operator control:
Press any button on the operator control or move the joystick. The system turns on.

Using the battery charge indicator

Battery
charge
indicator
The battery charge indicator (located above the on/off
button) is used to indicate that your wheelchair power
is on and provides an estimate of the remaining
battery capacity.
Any green LED's indicate that your batteries are well
charged.
If only amber and red LED's are light, the batteries are
moderately charged. Recharge your batteries before
you make a long trip.
If only red LED's are light, the batteries are running
out of charge. Recharge as soon as possible.
3
LiNX 200
vA - 2016-09