Operating Console Functions; Switching On / Off; Emergency Stop - Vermeiren SE04 Manuel D'utilisation

4

Operating console functions

The operating console with chin controller enables you to control all driving components as well
as the motors to adjust your body position. For your own safety, and to prevent that the wheelchair
gets damaged, movements are monitored by the electronics. This may result in block of
movement, speed decrease or complete stop.
4.1

Switching ON / OFF

Put the joystick in the neutral (central) position before pressing the ON/OFF button.
If the console is switched on with the joystick out of the neutral position, the wheelchair will
not drive. Release the joystick (return to neutral) within 5 seconds to unlock the drive. If the
joystick is not released within 5 seconds, the fault turns into a module fault which is
indicated by the red blinking LED in the ON/OFF buttons. The wheelchair will not drive. To
clear the module fault, release the joystick and switch the operating console OFF and then
ON again.
• To switch the operating console ON: either press the green ON/OFF button (1) on the chin
controller, or press the ON/OFF screen button (2) or chin controller button (3).
The start screen is displayed for a few seconds, after which the operating screen appears.
The LED (status indicator) in the ON/OFF buttons goes on. When it turns green, the operating
console is ready for operation. When the LED starts blinking in red, there is a failure, see §4.2
and §5.
• To switch the operating console OFF when it is ON: either press the ON/OFF button (1) on
the chin controller, or press the ON/OFF screen button (2) or chin controller button (3).
The operating console will power down and the status indicator
goes out.
Switching ON/OFF

4.1.1 Emergency stop

If you need to stop a driving or body-positioning movement quickly, press the ON/OFF button to
perform an EMERGENCY STOP. The wheelchair will come to a halt quickly.
3
7
Operating console functions
1
EN
SE04, SE104
2021-11
NL
2