Publicité
TXCONFIG-HART Interface
Quick Guide
The TxConfig-HART is a configuration interface for transmitters with HART
protocol. It can be used together with the configuration software TxConfig.
INTERFACE INSTALLATION
In the TxConfig-HART model there is a USB communication interface,
which must be connected to the available USB port. Windows will request
the proper driver installation, which is found in the CD that is provided with
the transmitter.
USB Drivers Installation
The drives installation steps may vary according to the machine, even for
the same version of an operating system. The following steps are only to
provide guidance.
1. Insert the CD shipped with the transmitter in the CD-ROM drive.
2. Connect the interface the PC USB port. Windows® will acknowledge
the presence of new hardware and a few seconds later it will start the
drivers installation process.
3. The found new hardware wizard will be displayed, and you will be asked if
you want to install the driver from the Windows Update website. Select
"No, not this time", and then click "Next".
4. Select "Install from a list or specific location (Advanced)" and click
"Next".
5. Select "Search for the best driver in these locations" and check "Search
removable media". Click "Next". If installation files are not in a CD,
check "Include this location in the search" and show the file path.
6. If a prompt warns you that it does not support Windows® XP, click
"Continue anyway".
7. The interface driver files will be copied to the computer and after a few
seconds a screen is displayed informing that the software installation as
been concluded. Click "Finish".
8. In some situations, the steps described above may be repeated again.
Follow the same procedures.
In later uses of the interface, Windows® may require the driver installation
again. In this case, the same installation wizard will be displayed, and you
will have to select the option "Install software automatically
(recommended)", as the driver may already be in the computer.
ELECTRICAL CONNECTIONS
English
Connect the interface to the transmitter as shown in the following figures
depending on the model you are configuring;
Connect the TxConfig-HART interface to a free USB port on the PC;
Launch the previously installed TxConfig software in order to perform the
transmitter configuration
1. TxIsoPack-HART transmitter
2. TxIsoRail-HART transmitter
OPERATION
Follow the instructions from the TxConfig software.
Status LED:
Blinking Tx LED: sending data to the transmitter.
Blinking Rx LED: data are being received from the transmitter.
FEATURES
Easy installation;
USB communication with the PC and serial with the transmitters;
Pins to HART device: polarity insensitive test clips;
Compatible with USB 1.1 and 2.0;
Rx / Tx LED indicators;
Power: no external power supply required;
Operation Temperature: 0 to 50 ºC;
Storage Temperature: -40 to 80 ºC;
Humidity: 0 to 95 % (no condensing);
Isolation: 1500 Vdc galvanic isolation between transmitter and PC;
Operation System: Windows 2000 / XP / Vista and Windows 7;
Dimensions: 70 x 45 x 18 mm
T X C O N F I G - H A R T
I N T E R F A C E
Q U I C K G U I D E
SAFETY INFORMATION
Any control system design should take into account that any part of the system has
the potential to fail. This product is not a protection or safety device and its alarms
are not intended to protect against product failures. Independent safety devices
should be always provided if personnel or property are at risk.
Product performance and specifications may be affected by its environment and
installation. It's user's responsibility to assure proper grounding, shielding, cable
routing and electrical noise filtering, in accordance with local regulations, EMC
standards and good installation practices.
QG 5010025
Publicité
