Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.4.9. Resetting data in the memory
At any time, the memory of the Multi display can be returned to factory settings. To
do so, a memory reset command is accessible in the menu. The following
parameters are restored in the memory:
•
Speed unit:
•
Depth unit:
•
Distance unit:
•
Temperature unit:
•
Speed damping:
•
Speed calibration coeff.:
•
Temp. calibration coeff.:
•
Keel offset:
•
Depth alarms:
0
•
Speed alarms:
0
•
Temperature alarms:
0
•
Battery alarm:
•
Countdown timer init.:
•
Trip log:
•
Total log:
•
Simulation mode:
•
Backlighting level:
menu
Press
for 2 seconds, then
displayed, then activate (on) or deactivate (OFF) the reset using
the
and
Press
to exit setup mode, or time out after 10 seconds.
2.5. Standby
To save energy on board, the "MULTI" display can be placed on standby by pressing
for 5 seconds on the
Standby mode switches off backlighting, the screen, stops sensor measurement and
processing of NMEA input and output interfaces. Only the vital bus management and
keyboard functions remain active. Active displays present on the bus indicate
measurement impossible with an OFF icon instead of the data.
menu
keys.
key.
Installation and Operation Manual S400 series
Knots
Metres
Nautical Miles
°Celsius
10 seconds
Slope at 1.0
Offset to 0
0
deactivated, high and low threshold at
deactivated, high and low threshold at
deactivated, high and low threshold at
deactivated, low threshold at 0
10 minutes
0
0
deactivated
0 (OFF)
until the "rESEt" page is
15
Publicité
Chapitres
Table des Matières
