Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.4.3. Calibrating the water temperature
The water temperature is calibrated in the calibration menu, by replacing the water
temperature displayed with the water temperature estimated by the user, or
measured using another source.
menu
Press
for 2 seconds, then on
is displayed, then adjust the required value using the
keys.
Press
to exit setup mode, or time out after 10 seconds.
2.4.4. Calibrating by speed
The speedometer sensor can be calibrated by speed or by distance.
The boat speed is calibrated in the calibration menu, by replacing the boat speed
displayed with the boat speed estimated by the user, or measured using another
source.
We recommend you navigate at constant speed. Note the speed displayed on a GPS
receiver (it should be greater than 5 kts) or measure the time taken to cover a given
distance (speed between 5 and 20 kts, in calm seas, with little current).
menu
Press
for 2 seconds, then on
is displayed, then adjust the required value using the
keys.
Press
to exit setup mode, or time out after 10 seconds.
2.4.5. Calibrating by log
After resetting the Trip log to "0", cover a specific set distance (identified on a
chart). To partly compensate for current and tide effects, cover the distance in both
directions, parallel to the current.
In the calibration menu, replace the distance displayed for the Trip log with the real
distance covered.
menu
Press
for 2 seconds, then on
page is displayed, then adjust the required value using the
and
keys (max. ±50% adjustment of the value measured by
the Trip log).Press
seconds.
menu
until the "tEMP" setup page
menu
until the "SPEEd" setup page
menu
until the "LOG" setup
to exit setup mode, or time out after 10
Installation and Operation Manual S400 series
and
and
13
Publicité
Chapitres
Table des Matières
