Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
An alarm can be cancelled and inhibited for 3 minutes by pressing on any key on the
keypad. After this period, a new alarm may be triggered when the measurement
sensor once again exceeds the programmed thresholds.
Several devices interconnected on the bus, can be used to relay a sensor alarm to
other compatible displays present on the network. Example: a boat speed alarm can
be viewed on all "MULTI" displays present on board.
The Depth and Boat speed data can be monitored by configuring high and low alarm
thresholds.
The Battery voltage data can be monitored by configuring the low threshold alarm.
2.3.1. Setting the depth alarm thresholds
menu
Press
, then once again on
threshold page for the sounder, then adjust the required value of the
threshold using the
Press
to exit setup mode, or time out after 10 seconds.
menu
Press
, then once again on
threshold page for the sounder, then adjust the required value of the
threshold using the
Press
to exit setup mode, or time out after 10 seconds.
2.3.2. Setting the speed alarm thresholds
menu
Press
, then once again on
threshold page for the speed, then adjust the required value of the
threshold using the
Press
to exit setup mode, or time out after 10 seconds.
menu
Press
, then once again on
threshold page for the speed, then adjust the required value of the
threshold using the
Press
to exit setup mode, or time out after 10 seconds.
menu
to display the "dEEP" high
and
keys.
menu
to display the "SHAL" low
and
keys.
menu
to display the "SPEEd
and
keys.
menu
to display the "SPEEd
and
keys.
Installation and Operation Manual S400 series
" low
" high
11
Publicité
Chapitres
Table des Matières
