Using Laundry Product Dispensers - Whirlpool Cabrio W10560173B Guide D'utilisation

Using Laundry Product Dispensers

NOTE: Do not add single-dose laundry packets, color-safe
bleach, Oxi-type boosters, or fabric softener crystals to
dispensers. They will not dispense correctly.
4.
Add HE detergent
Detergent tray
Add a measured amount of
HE detergent into detergent tray. This
tray holds 3 oz. (89 mL). Do not overfill tray - adding too
much detergent may cause detergent to be dispensed into
the washer too early.
IMPORTANT: Use only High Efficiency detergents. The
package will be marked "HE" or "High Efficiency." Low-water
washing creates excessive sudsing with a regular non-HE
detergent. Using regular detergent will likely result in longer
cycle times and reduced rinsing performance. It may also
result in component failures and noticeable mold or mildew.
HE detergents are made to produce the right amount of
suds for the best performance. Follow the manufacturer's
instructions to determine the amount of detergent to use.
HELPFUL TIP: See "Washer Maintenance" for information
on recommended method of cleaning washer dispenser trays.
5.
Add liquid chlorine bleach
to dispenser
Liquid
Chlorine Bleach
Do not overfill, dilute, or use more than 1 cup (250 mL).
Do not use color-safe bleach or Oxi products in the same
cycle with liquid chlorine bleach.
6.
Add liquid fabric softener or
Oxi to dispenser
Fabric softener tray
Pour a measured amount of liquid fabric softener or
Oxi-type boosters, into tray; always follow
manufacturer's directions for correct amount of fabric
softener or Oxi based on your load size. Close dispenser
drawer, then select Fabric Softener and/or Oxi option. Oxi
is added during main wash and Fabric Softener is added
during rinse.
IMPORTANT: Fabric Softener/Oxi option must be selected
to ensure proper distribution at correct time in cycle. Do
not overfill or dilute. Overfilling dispenser will cause fabric
softener to immediately dispense into washer.
If Extra Rinse option is selected, fabric softener will be
dispensed into the last rinse.
It is normal for a small amount of water to remain in the
dispenser at the end of a cycle.
7.
Press POWER to turn on washer
Make sure the dispenser drawer is closed completely, then
press POWER to turn on the washer.
Oxi tray
9