Walk Test; Important; Led Display; Operational Modes - RISCO Group Wireless WatchOUT WL T312 Manuel D'installation

Walk test

Two minutes after applying power, walk test the protected area to verify proper operation.
Adjust the moving PIR for required detection range and reliability.

IMPORTANT!

Both upper and lower detection areas must be blocked simultaneously for detection to occur, see
figure 7 below.

LED Display

LED
RED

Operational Modes

Operational Mode
Normal
Test (walk test)
Write (for enrolling)
NOTE:
After power up the detector enters into test mode for a period of 20 minutes (disregarding the DIP Switch Modes
Position).

Transmitter/Receiver Communication link setup

The detector must identify itself to the system's receiver by writing its coded message into the
receiver's address memory. This is accomplished by performing the following steps:
1. Set the receiver to Write Mode.
2. Remove the insulation material from the battery and place it in the battery holder on the
PCB on the right direction (pay attention to the "+" and "–" diagram on the PCB)
3. Send a WRITE message by closing both of the tamper switches (back and cover) for at
least 3 seconds.
4. Verify that the detector has been identified by the receiver.
Figure 7
State
Steady
Description
Dead time (between detection alarms) is 2.5 Minutes.
Dead time (between detection alarms) is 2.5 sec.
The unit transmits a WRITE message each time both the Tamper
Switches (back and cover) are closed for at least 3 seconds.
Installation Manual
Description
Indicates ALARM
9