Utility Mode/Firmware Update; Utilities Modes; Firmware Update; Changing The Settings - Pioneer DDJ-WEGO3 Mode D'emploi

Utility mode/Firmware update

Utilities modes

The following settings can be changed:
! Demo mode setting
! Auto standby setting
! Pulse mode (illumination) setting
Launching utilities mode
1 Sets the unit on standby status.
LED next to [STANDBY/ON] button on the upper right of the unit is in
red lighted status.
2 While holding down the [LOAD] button on the left-
side deck and the [LOAD] button on the right-side deck,
press the [STANDBY/ON] button.
The unit starts up in utility mode. (The [SYNC] buttons on both decks
light up.)
3 For items for which you would like to change the
settings, change the settings.
See the Changing the settings below for the settings that can be
changed, and for the setting change methods.
4 Check that the [SYNC] button is in lighted state, and
then press the [STANDBY/ON] button to restart the unit.
Performing restart may be necessary to reflect the changed setting.
Caution
When the [SYNC] button is flashing, this unit is writing the setting.
If the [STANDBY/ON] button is pressed to perform restart while the
[SYNC] button is flashing, the set values are not reflected in the unit.

Changing the settings

*: Setting upon purchase
0 Demo mode setting
After restarting the unit, if no operation is performed for a certain set
period, it starts in demo mode. The amount of time until start in this
demo mode can be changed.
Press the [HOT CUE/SAMPLER] mode switching button
on the left deck.
Left deck [1] button lighted: 10 min*
Left deck [2] button lighted: 5 min
Left deck [3] button lighted: 1 min
Left deck [CUE] button lighted: OFF
0 Auto standby setting
When the auto standby setting is on and if four hours have passed
while the following conditions are all met, the unit automatically enters
standby status.
! No buttons or controls, etc. except for the [MIC VOL] control on the
unit are operated.
! Audio signals are not input to this unit (excluding microphone audio
input).
Press the [HOT CUE/SAMPLER] mode switching button
on the right deck.
Right deck [1] button lighted: ON*
Right deck [CUE] button lighted: OFF
10
En
0 Pulse mode (illumination) setting
This unit is equipped with two types of pulse mode (illumination lighted/
flashing mode).
Press the [HEADPHONES SELECT MASTER] button.
[HEADPHONES SELECT A] button lighted: Normal (Standard LED
lighted/flashing pattern)*
[HEADPHONES SELECT B] button lighted: Moderate (LED brightness
suppress lighted/flashing pattern)

Firmware update

Firmware is the software required for controlling the unit.
To determine whether there is a firmware update for the unit, and to
download the update software, check the Pioneer DJ support site below.
http://pioneerdj.com/support/
Cautions
! When performing a firmware update, first disconnect the iPhone/
iPad connection.
! Firmware updates for the unit cannot be performed on an iPhone/
iPad.
A separate computer (Windows/Mac) is necessary.
1 Download the update software on the computer
(Windows/Mac).
Download the update software from the Pioneer DJ support site below.
http://pioneerdj.com/support/
2 Connect this unit to your computer via a USB cable.
3 Press the [STANDBY/ON] button on the unit, and set
the unit to on status.
If the unit is in standby status, update cannot be performed.
4 Execute the update software that was downloaded in
Step 1.
When the update is complete, the unit goes into standby status.
5 Press the [STANDBY/ON] button on the unit, and set
the unit to on status.
The unit starts up with the updates applied.