Table des Matières
Publicité
Manuel d'utilisation CellaPort PT 14x
19.3.5 Configuration des signaux E/S
La touche « C » permet de visualiser l'ensemble des paramètres con-
cernant le paramétrage des LEDs et buzzer
------------------------------------------------------------------
Submenu I/O
------------------------------------------------------------------
C: [STATUS LED CONTROL]
D: [BUZZER CONTROL]
M: [OPTIONS]
ESC: Back to MAIN-MENU
------------------------------------------------------------------
>I/O >
Le réglage des LED ou du buzzer se fait via les sous-menus spécifiques.
LED-Control:
------------------------------------------------------------------
Submenu CONTROL LED
------------------------------------------------------------------
GRN.LED source ... ready-signal
GRN.LED function
GRN.LED delay time ...
GRN.LED hold time ....
S: Set source
F: Set function
D: Set delay time
O: Set hold time
ESC: Back to MAIN-MENU
------------------------------------------------------------------
>I/O >LED CONTROL >
Set status LED source:
0: Off
1: Ready-Signal
2: Lambda 1
3: Lambda 1 premax
4: Lambda 2
5: Lambda 2 premax
6: Quotient
7: Quotient premax
8: Signal intensity
9: Dirt Alert
10: Ambient Temperature
11: Lambda 1 ATD Trigger
12: Lambda 2 ATD Trigger
13: Quotient ATD Trigger
14: Lambda 1 ATD tAct
15: Lambda 2 ATD tAct
16: Quotient ATD tAct
------------------------------------------------------------------
Your choice>
level/signal
0.00 s
0.00 s
32
Publicité
Table des Matières
