Table des Matières
Publicité
Manuel d'utilisation CellaPort PT 14x
------------------------------------------------------------------
-
PT 143 AF1
-
PT40SW101/0
------------------------------------------------------------------
Qu range ....
650.0 - 1700.0 C
Qu epsilon ratio ...... 100.0 %
Qu check L2
rel.limit
Qu abs.limit
650 C @
Qu linearization .......... off
Qu filter ..........
Qu memory type ............ off
Unit .................. Celsius
Terminal assigned to ...... USB
Autoprint ......... on (cyclic)
Print cycle time .....
Protocol address .......... 001
Display ........... temperature
Key lock .................. off
------------------------------------------------------------------
>
19.3 Sous-menu
19.3.1 Configuration du mode quotient (bi-chromatique)
La touche « 0 » permet de visualiser l'ensemble des paramètres
d'acquisition concernant la voie quotient.
------------------------------------------------------------------
Submenu QUOTIENT
------------------------------------------------------------------
Qu epsilon ratio ...... 100.0 %
Qu check L2
rel.limit
Qu abs.limit
650 C @
Qu linearization .......... off
Qu filter ..........
Qu memory type ............ off
C: [CONFIG EPSILON TABLE]
E: Epsilon
U: [Q-CHECK]
L: [LINEARIZATION]
F: Filter
M: [MEMORY]
P: Show parameter
Q: Show calibration data
O: Show signal intensity
X: Show measure temperatures
Y: Show premax measure temps.
ESC: Back to MAIN-MENU
------------------------------------------------------------------
>QUOTIENT >
19.3.2 Lambda 1
La touche « 1 » permet de visualiser l'ensemble des paramètres
d'acquisition concernant la voie 1 (L1).
650-1700C - 00/00112 - Job
QP 0,95/1,05um
Version 01.02
DISPLAY source ....... quotient
10.00 %
50.00 %
0.10 s
GRN.LED source ... ready-signal
GRN.LED function
GRN.LED delay time ...
GRN.LED hold time ....
BUZZER
0.1 s
10.00 %
50.00 %
0.10 s
- 21.10.13
10.07.13
source ............ off
30
-
-
level/signal
0.00 s
0.00 s
Publicité
Table des Matières
