Reer Neo Digital Notice D'utilisation page 22

Troubleshooting
The status LED does not light up
Make sure that both units are switched on.

Check the connection of the mains adapter to the wall power socket and the unit.

Exchange the batteries and/or check the polarity.

The status LED flashes green
The parent unit receives sounds. Turn up the volume on the parent unit to make sure

that you hear the sounds from your baby.
The status LED flashes red
Long flashing: Batteries are flat. Replace the batteries or connect the unit to the power

supply.
Short flashing: maximum range is exceeded. Reduce the distance between the baby and

parent unit.
No sound transmission despite established connection
The volume is set too low. Press the + button to increase the volume.

22