gala gar GALA ELECTRONICS 221 ACDC Manuel Technique D'instructions page 33

0
20. Use the flow control valve to adjust the flow of gas as required
while the gas is flowing out.
21. Set the required welding parameter values on the user interface.
When the remote control pedal is connected and the relative
locking screw is tightened the welding current will vary in relation
to the pressure exerted on the pedal.
The system is ready to start welding.
31
GALA ELECTRONICS 221ACDC GALA ELECTRONICS 221ACDC GALA ELECTRONICS 221ACDC GALA ELECTRONICS 221ACDC
E E E E GB GB GB GB