Whirlpool AGB 641/WP Manuel D'emploi page 30

PROBLEM
LINE INDICATOR LAMP
DOES NOT LIGHT
ON STARTING NO
WATER SUPPLY
WASHING DOES
NOT FUNCTION
THE DRUM RINSING
WATER DOES NOT
HEAT UP OR THE
TEMPERATURE IS
INSUFFICIENT
WATER FILLING DOES NOT
STOP
THE WASH IS INSUFFICIENT
INSUFFICIENT RINSING
STAINS AND MARKS ON
GLASSES AND CUTLERY
ENGLISH
CAUSE
Bulb burnt.
Line voltage lacking.
Water tap closed.
Water trap dirty.
Pressure switch defective.
Solenoid coil burnt.
Membrane broken or defective.
Door micro shorting.
Pushbutton defective.
Timer defective.
Feed water temperature.
Heater burnt.
Thermostat shorting.
Switch jammed.
Heater covered with chalk deposit.
Boiler coverd with chalk deposit.
Solenoid valve coil burnt.
Membrane broken or defective.
Air trap dirty.
Pressure switch broken or shorting.
Pressure switch tube disconnected.
Nozzles blocked.
Water temperature too low.
Insufficient detergent.
Detergent not suitable.
Detergent badly dosed.
Pumps not working.
Nozzles blocked.
Solenoid valve dirty.
Water supply pressure not correct.
Boiler covered by chalk deposit.
Water with chalk minerals and
magnesium with values not within
7/10 degrees F. Water with other
minerals (Fe-etc.)
27
SOLUTION
Replace.
Check supply switch or wall socket.
Open tap.
Clean.
Replace.
Replace.
Replace.
Replace.
Replace.
Replace.
Check.
Replace.
Replace.
Replace.
Clean.
Clean.
Replace.
Replace.
Replace.
Replace.
Re-connect.
Clean.
Check.
Ask for intervention.
By detergent technician.
Replace.
Clean.
Clean.
Check water circuit.
Clean.
Check and ask for the intervention
of a specialist technician.