Table des Matières
Publicité
5. Setting the Protocol and the Camera ID
Before installing the camera, configure the camera ID and the communication protocol using the DIP switches.
a. Protocol Setting
PRO0
PRO1
PRO2
Pin 1
Pin 2
Pin 3
OFF
OFF
OFF
ON
OFF
ON
OFF
ON
OFF
ON
ON
ON
Press F4 on the controller and select the same protocol as the one on the camera.
b. Camera ID Setting
c. RS485 Resistor
It is recommended to set the terminal resistor of the last camera in the series to ON. The switch is placed on the
alarm and connection board.
CAMCOLD4_v2
There are two sets of DIP switches. Note that the default protocol is
Pelco-D with a baud rate of 2400 bps.
Protocol / Baud
Pelco-D, 2400 bps
Pelco-D, 9600 bps
Pelco-P, 4800 bps
Pelco-P, 9600 bps
Make sure the camera ID on the DIP switches and the camera ID on the
controller are identical. When controlling more than one camera, it is
recommended to memorize the IDs and the location of each camera.
By changing the DIP switch setting, you can set the binary number for each
camera ID (1 ~ 63, except 0). Default camera ID is 1. Example: Set the
camera ID as 10: 0 + 2 + 0 + 8 + 0.
ZM1
ZM2
NT/PAL
Pin 4
Pin 5
OFF
OFF
OFF
OFF
ON
OFF
ON
OFF
OFF
ON
OFF
ON
ON
ON
ON
ON
5
Camera
Pin 6
OFF
SONY X18, NTSC
OFF
CNB X26, NTSC
OFF
CNB X22, NTSC
OFF
LG X27, NTSC
ON
SONY X18, PAL
ON
CNB X26, PAL
ON
CNB X22, PAL
ON
LG X27, PAL
VELLEMAN
Publicité
Table des Matières
