Connecting Usb Drives; Using Internal Hdd; Using Sd Memory Cards; Accessing Network Drives - Zappiti Player Guide De Démarrage Rapide

Connecting USB Drives

To connect a USB drive, ensure you are on the main screen of the player menu and connect the USB drive
to an USB port of the player. The player will recognize the USB drive, and will show an item corresponding
to the USB drive on the main screen.
When connecting a USB drive requiring significant power (such as USB HDD), use an external power
supply for the USB drive. Power provided by the USB ports of the player may not be enough for correct
functioning of the USB drive.
Do not disconnect or switch off the USB drive when some write operation is in progress.

Using Internal HDD

To insert the internal 3.5" SATA HDD, ensure you are on the main screen of the player menu, open the
HDD rack door, insert the HDD into the HDD rack and close the HDD rack door. The player will recognize
the internal HDD, and will show an item corresponding to the internal HDD on the main screen of the
player menu.
Do not eject the internal HDD when some write operation is in progress.
It is recommended to use "green" HDD models with small RPM value, small heat emission, and small
power consumption; for more information, please see here:
http://dune-hd.com/support/hw_compat/

Using SD Memory Cards

To insert an SD memory card, ensure you are on the main screen of the player menu and insert the memo-
ry card into the SD card slot of the player. The player will recognize the memory card, and will show an item
corresponding to the memory card on the main screen. Some SD memory cards may not be recognized by
the player or may work incorrectly; in such a case, use other models of SD memory cards.
Do not eject the SD memory card when some write operation is in progress.

Accessing Network Drives

To connect a network drive using SMB or NFS protocol, ensure you are on the main screen of the player menu,
press the "MENU" RC button, and choose "Create Network Folder", then fill the parameters of the network drive
as needed. The player will show an item corresponding to the configured network drive on the main screen.
To browse the list of network resources accessible via SMB or UPnP protocols, use "Network
item on the main screen of the player menu. NOTE: If some network resources are not shown by the
player, you may need to wait some minutes and then retry (or press the
"Refresh" command).
Formatting HDD
To format a HDD attached to the player, select the drive item on the main screen of the player menu,
press the "INFO" RC button and choose "Format
to format an already existing disk partition only). The player will format the disk using EXT2/EXT3/NTFS
filesystems.
"MENU"
Disk" (to format the entire disk) or "Format
Browser"
RC button and choose
Partition" (or
English
9