Preparation For Use - SKF TIH 100m Mode D'emploi

4

PREPARATION FOR USE

• Place the TIH 100m in the horizontal position on a stable surface.
• Connect the mains plug to a suitable mains supply.
• Plug the remote control into the connector on the carrying handle side of the
heater.
• Mount the swivel stud on the vertical post side of the swivel arrangement. See
the illustrations at the beginning of this manual. Position the large yoke swivel
on the swivel stud.
• For workpieces with an internal diameter large enough to fit over the inductive
coil, follow these steps:
- Open the foldable bearing support and position them as shown on the
illustrations at the beginning of this manual.
- Place the workpiece over the inductive coil using appropriate lifting
equipment.
- For best performance, adjust the position of the workpiece so that the
inductive coil is in the centre.
- Close the swivel yoke so that it completely covers the top of both vertical
supports.
• For workpieces that do not fit over the inductive coil, follow these steps:
- Choose the largest of the three yokes that fit through the internal diameter
of the workpiece.
- Slide the workpiece onto the yoke that you have selected.
- Heavy workpieces (= 9 kg (19.8 lbs)) that must be installed on the top yoke
should be supported until the yoke is in the correct position on the coil side
post. The heater may tip over if the workpiece is not supported.
- Position the yoke on the TIH 100m with the bright underside resting evenly
on the two vertical supports.
• If you will use TEMP MODE, plug the temperature probe into the connector on
the carrying handle side of the heater. Place the magnetic end of the probe on
the inner ring of the bearing or on the innermost surface of the workpiece.
• Switch on the TIH 100m.
• Observe the self-test of the remote control display and signal tone.
SKF TIH 100m 11