Replacing The Filters - Black & Decker HLVC315B Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

English

MAINTENANCE

WARNING:

serious personal injury, turn unit off and lock

off the tool before making any adjustments or

removing/installing attachments or accessories.

An accidental start‑up can cause injury.

Your BLACK+DECKER power tool has been designed to

operate over a long period of time with a minimum of

maintenance. Continuous satisfactory operation depends

upon proper tool care and regular cleaning.

Cleaning

WARNING:

of all air vents with clean, dry air at least once a

week. To minimize the risk of eye injury, always

wear ANSI Z87.1 approved eye protection when

performing this procedure.

WARNING:

harsh chemicals for cleaning the non‑metallic parts

of the tool. These chemicals may weaken the plastic

materials used in these parts. Use a cloth dampened

only with water and mild soap. Never let any liquid get

inside the tool; never immerse any part of the tool into

a liquid.

Dust Bowl (Fig. G)

WARNING:

vacuum without its filters.

iMPORTAnT: Maximum dust collection will only be

obtained with clean filters and an empty dust bowl. If dust

begins to fall back out of the product after it is switched off,

this indicates that the dust bowl is full and requires emptying

To Empty the Dust Bowl (Fig. g)

1. Place the dust bowl over a trash bin and remove the dust

bowl

from the main housing

bowl

counterclockwise and pulling the dust bowl

away from the main housing.

2. Remove the filter assembly

dust bowl

3. Shake or lightly brush any dust from the filter assembly.

4. Empty the dust from the dust bowl

and wash if necessary. Ensure that the dust bowl is

completely dry before using.

5. Place filter assembly into position in the dust bowl.

6. Install the dust bowl

ensuring the dust bowl tabs

housing slots

as shown in Fig. G and rotate the dust

bowl clockwise to lock it firmly into position.

To reduce the risk of

Blow dirt and dust out

Never use solvents or other

Never use this cordless hand

by twisting the dust

by pulling it out of the

into a trash bin

onto the main housing

aligns with the main

Cleaning the Filters (Fig. G)

Removing Pre‑filter

1. Place the dust bowl over a trash bin and remove the dust

bowl

away from the main housing.

2. Remove the filter assembly

dust bowl.

3. Twist counterclockwise and pull the pre-filter

seperate it from the filter

4. Remove the pre-filter and shake or lightly brush any dust

from the filter and pre-filter.

5. Empty any dust from the dust bowl

and wash if necessary. Ensure that the dust bowl is

completely dry before using.

6. Wash the pre-filter

warm, soapy water. Ensure that both are completely dry

for 12 hours before using.

7. Install the pre-filter onto the filter, ensuring the filter

tabs

pre-filter clockwise to lock it firmly into position.

8. Install the filter assembly into the dust bowl.

9. Install the dust bowl onto the main housing, ensuring

the dust bowl tabs

slots

clockwise to lock it firmly into position.

Cleaning the Filter

1. Once the filter and pre-filter are removed from the

dust bowl shake off or lightly brush any dust from the

pre-filter

2. Rinse out the dust bowl with warm soapy water.

3. Wash the filters regularly using warm, soapy water and

ensure that it is completely dry before using again. The

cleaner the filter is, the better the product will perform.

4. It is very important that the filters are completely dry and

correctly in position before use.

5. Ensure the filters are completely dry for 12 hours

before refitting.

6. Follow instructions in the Removing pre‑filter section for

assembly instructions.