Water Connection - Sabiana Atlas STP Manuel D'installation Et D'entretien

EN
According to the dimensions and the weight of the
appliance and the characteristics of the wall have to
be prepared two steel brackets of the right section
and dimension.
Connect the brackets with metal ropes, chains, rods
or any other suitable means.
Fix the air heater with four M8 screws and washers on
the four suspension hooks.
Lift the appliance with adequate means and hook it
on the suspensions.
Mount the diffuser duct by fixing it with tour M6
screws, elastic and flat washers on the threaded in-
sert of the air heater.
direct the diffusion blades in the way that the air
screen covers the door gap.
14

WATER CONNECTION

on open system (e.g. when using well water), the wa-
ter used should be cleaned from suspended matter
by means of a filter which should be located in the
inlet. otherwise there is a risk of erosion due to sus-
pended matter.
You must also ensure that the unit is protected from
dust and other substances that cause an acid or al-
kali reaction when combined with water (aluminum
corrosion).
Supply scheme (warm or hot water).
Don't let trash or impurities penetrate into
the battery, since they could damage the appli-
ance and even arrive to the thermal power plant
where they could ruin pumps, boilers, valves, etc.
To prevent leakage use hamp and tightening paste
for the water charge and discharge.
Equip the tubes with 3-piece joints and exclusion
valves.