Unit Identification; Main Components; Transport - Sabiana Atlas STP Manuel D'installation Et D'entretien

The appliance may not be used:
–
for outdoor air treatment
–
for installation in moist rooms
–
for installation in explosive atmospheres
–
for installation in corrosive atmospheres
Make sure that the environment where the appliance
is installed does not contain substances that cause
the corrosion of the aluminium fins.
The unit works with warm water, hot water or with
steam, which is producted by gennerators (boilers).

MAIN COMPONENTS

The casing and the diffuser, consist of hot galva-
nized and prepainted steel.
The heat exchange battery consists of aluminium
fins bonded with steel tubes Ø 22 mm or copper
tubes Ø 22 mm headers.
The battery is equipped with threated female head-
ers, on request with flange PN 16.
The electric ventilator is composed of a statical-
ly and dynamically balanced fan with aluminium
blades and is directly fixed on the shaft of the asyn-
chronous, three-phase electric motor, closed type. It
is connected with the casing by means of a strong,
basket-like, elastic metal support of anti-vibration
means.

UNIT IDENTIFICATION

Each unit is provided with an identification label,
which informs you on the construction data and the
model type.
The identification label is positioned on the rear side
of the unit.

TRANSPORT

The appliance is transported and delivered in an up-
right position packed in a cardboard box.
The diffuser is transported unpacked as a separate
part.
After having unpacked the appliance please make
sure that it does not present any damages and that it
is corresponding to the ordered version.
In case of damages or if the code of the appliance
should not correspond to the ordered model, please
contact the reseller ·and indicate the series as well as
the model number.
EN
11