Technical Assistance - S&P METEOR-ES N Instructions D'utilisation

Speed Control
Rotating the diffuser grille
The grille rotation is controlled by this switch. This option enables the airflow
to be distributed in the room, so it does not discharge onto the same position
(breeze effect).
MAINTENANCE
Disconnect the appliance from the mains before cleaning.
• These devices require no special maintenance. Do not try to dismantle the appliance; it will
be sufficient to wipe the outside with a damp cloth and a little mild detergent. Do not use
solvents or abrasive products for cleaning.
• To clean the dust in the inlet and outlet grilles, as well as the fan blades, you can use blown
air or a vacuum cleaner.
• If you are not going to use the device for a long period of time, after cleaning it as mentioned
above, store it in its original packing in a dry and dust-free location.

TECHNICAL ASSISTANCE

S&P's large Technical Service network will guarantee adequate technical assistance.
If a fault is observed in the unit, please contact any of the mentioned technical service offices
and they will attend to your problem.
Any manipulation of the appliance by personnel not belonging to the Official S&P Services will
result in your guarantee being void.
For any queries regarding S&P products please contact any branch of our After Sales Service
network if you are in Spain, or your regular dealer in the rest of the world. To find your nearest
dealer, visit our website at www.solerpalau.com
END OF SERVICE LIFE AND RECYCLING
• Our commitment to future generations oblige us to recycle materials; please
remember to dispose of all unwanted packaging materials at the appropriate
recycling points, and to place obsolete equipment at the nearest waste mana-
gement point.
THE MANUFACTURER WILL NOT BE HELD LIABLE FOR DAMAGE TO PERSONS AND/OR
PROPERTY RESULTING FROM FAILURE TO COMPLY WITH THESE INSTRUCTIONS.
= Stop
= Slow speed
= Medium speed
= Fast speed
Timer
The timer will allow you to
select the time it is in
operation, up to 180 minutes.
If the timer is not used, it
should be set to ON.
5