Problem Solving; Technical Assistance; Removal From Service, Disposal And Recycling - S&P HTB-140 Notice D'installation Et D'utilisation

All manuals and user guides at all-guides.com

PROBLEM SOLVING

IMPORTANT: Before working on the fan ensure that it is disconnected from the mains electricity
supply.
Problems
Fan does not start
Fan sounds noisy
Fan sounds noisy

TECHNICAL ASSISTANCE

S&P's large Technical Service network will guarantee adequate technical assistance.
If a fault is observed in the unit, please contact any of the mentioned technical service offi ces and
they will attend to your problem.
Any manipulation of the appliance by personnel not belonging to the Offi cial S&P Services will re-
sult in your guarantee being void.
For any queries regarding S&P products please contact any branch of our After Sales Service net-
work if you are in Spain, or your regular dealer in the rest of the world. To fi nd your nearest dealer,
visit our website at www.solerpalau.com

REMOVAL FROM SERVICE, DISPOSAL AND RECYCLING

• If the appliance is not to be used for any length of time, we recommend returning it to its
original package and storing it in a dry, dust-free place.
• EU regulations and our commitment to future generations oblige us to recycle used ma-
terials; please remember to dispose of all unwanted packaging materials at the appro-
priate recycling points, and to drop off obsolete equipment at the nearest waste manage-
ment point.
THE MANUFACTURER WILL NOT BE HELD LIABLE FOR DAMAGES TO PEOPLE AND/OR PRO-
PERTY DUE TO NON-COMPLIANCE WITH THESE WARNINGS.
S&P RESERVES THE RIGHT TO MODIFY THE PRODUCT WITHOUT PRIOR NOTIFICATION.
Possible cause
1. Blown fuse or circuit breaker.
2. Loose connections to the ma-
ins supply
3. Fan blades not attached to
fan.
4. Loose screws.
5. Loose screws between fan
blades and motor housing.
6. Fan blades not seated pro-
perly.
7. Support plate not securely
fi tted to ceiling.
8. Fan blades out of balan-
ce.
12
Suggested solution
1. Check fuses or circuit breaker.
2. Tighten connections
3. Fit blades before starting fan.
4. Check all fan screws for
tightness.
5. Check fan blade screws for
tightness. Tighten if neces-
sary.
6. Check the fan blades sit
snugly in the motor housing
and with the same angle of
inclination.
7. C h e c k c e i l i n g s u p p o r t
screws.
8. Change the position of some
of the blades.