Publicité
Les langues disponibles
Les langues disponibles
DE Anl. 5020-0504/SCANTEMP 440 11.01.2005 15:18 Uhr Seite 6
ScanTemp 440 – Infrared Thermometer
Infrared Function
ScanTemp 440 is supplied with a default
emissivity of 0.95.
Press Mode key
follows.
Press emissivity key
The emissivity can be changed from 0.10 to 1.00.
Zum Messen betätigen Sie die Taste Messen
Keep press Mode key
(MAX), Minimum (MIN), Different between
MAX and MIN (DIF) and Average (AVG) readings
during the last measurement period.
Press Down key
Alarm (HAL) or Lo Alarm (LAL). For example:
When the reading 27 °C < LAL 27.1 °C, the Low
icon will flash and you will hear a beep sound.
The measurement range: -33 .. +500 °C.
ScanTemp will automatically shut off if left idle for more
than 60 sec, unless in PRB mode.
Thermocouple Probe Scan Function:
Press the mode key
This mode can only be reference when thermometer
probe is connected.
Connect the thermocouple with Scan-
Temp 440's thermocouple socket
and put the probe in or on the target,
the temperature will be displayed beside
the "PRB" icon.
The measurement range: -64 to +1400 °C.
ScanTemp 440 will automatically shut off if left idle for
more than 12 min in PRB mode.
After measure high temp, the probe may remain HOT
for a while.
10
for scrolling more display function as
key to adjust the emissivity.
key
for the Maximum
or Up key to change the High
until PRB appears: on the LCD.
ScanTemp 440 – Infrared Thermometer
Key pad:
Other Function:
Press Lock key for infrared LOCK mode
In Default,
ON/OFF.
Max, Min,
.
DIF, AVG,
Press °C/°F key for °C or °F transferred.
PRB mode:
In all modes:
Press Lock key for Backlight function
First
hold on
ON/OFF.
the Meas.
Press °C/°F key for Laser function ON/OFF.
key
Battery:
The ScanTemp440 incorporates visual low battery indica-
tion as follows:
Battery OK
Measurements
are possible
When the 'Low Battery' icon indicates the battery is low,
the battery should be replaced immediately with two
AAA, 1.5V batteries. Please note: It is important to turn
the instrument off before replacing the battery other-
wise the ScanTemp440 may malfunction.
Dispose of used battery promptly and keep away from
children.
Battery Low
Battery Exhausted
Battery needs to
Measurements are
be replaced,
not possible
measurements are
still possible
11
Publicité
