Closing The Door; Replacing The Lamp; Installation - Electrolux EK134S Notice D'utilisation

Masquer les pouces Voir aussi pour EK134S:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
There is too much con‐
densed water on the rear
wall of the refrigerator.
Door does not open easily. You attempted to re-open
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

8.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.

9. INSTALLATION

WARNING!
Refer to Safety chapters.
Possible cause
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been opened
often.
The FastFreeze function is
switched on.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
the door immediately after
closing.

8.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
3. If necessary, replace the defective
9.1 Location
Solution
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if nec‐
essary.
Refer to "FastFreeze func‐
tion".
Open the door only when
necessary.
Make sure the door is
closed completely.
Wrap food in suitable
packaging before storing it
in the appliance.
Wait a few seconds be‐
tween closing and re-open‐
ing of the door.
to assembly instructions.
door gaskets. Contact the Authorised
Service Centre.
Refer to the assembly
instructions for the
installation.
ENGLISH
59

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ek136s

Table des Matières