Introduction; Set Content; How Does The Ebode Ir Link M Work; Installing The Ebode Ir Link M - Ebode IR Link Série Guide De L'utilisateur

2. Introduction

Thank you for purchasing the ebode IR Link M. Our ebode proprietary eIR 2 x TM (pronounce
Irex) Technology guarantees a high level of immunity for InfraRed noise of direct sunlight,
CFL lighting and Flat Panel TV's (including Plasma, LCD and LED). It provides accurate
reproduction of the latest generation InfraRed codes that are used in remote controls of,
for instance, Set-Top Boxes and Media Players (incl. RC5/6, RCMM, XMP).
The ebode IR Link M is an InfraRed extender system that allows full InfraRed remote
control operation of A/V components located behind closed cabinet doors or other
concealed and/or out-of-sight locations. The ebode IR Link M uses power from the mains
(no battery required).
An InfraRed Extender in general consists of an IR (InfraRed) capture device, the Receiver,
a distribution circuit/connecting block, the Hub, and finally the IR LED output, the Emitter,
which flashes the IR signal to the A/V component.

3. Set content

The ebode IR Link M consists of 3 parts
1 IRLM Mini Surface Mount Receiver
1 IRHUB1A with 2IREDB IR Emitters attached for control of up to 2 devices.
1 12VDC Power supply

4. How does the ebode IR Link M work?

The IRLM Receiver receives IR signals from your remote controls. It then amplifies the
remote control signal and passes it to the attached Emitters. The small Emitters each
contain an IR transmitting LED and blink visibly when remote commands are passed. They
allow control of IR remote controlled audio/video components (such as your A/V
Receiver, DVR, satellite box, cable tuner, etc.) and are attached to the IR sensor
"window" on such components by a self adhesive film. When a handheld remote control
is operated and aimed at the ebode IR Link M, the IR commands will be passed to the
controlled equipment. The Mini Receiver can be positioned outside of the cabinet, for
instance close or attached to your flat panel, but always within line of sight of your hand
held remote control.
5. Are there conditions where the ebode IR Link M will not work?
Most brands and models of IR controlled equipment are usable with your ebode IR Link
M, with some exceptions like those using high frequency IR carriers, such as Bang &
Olufsen (ask your dealer).

6. Installing the ebode IR Link M

The Hub sockets are colour coded for easy plug & play installation of the IR Receiver and
IRED Emitters, which have coloured jacks.
Step 1: Place the ebode IR Link M IR Receiver in any convenient location so that the
InfraRed beam from your remote control has a direct view to the front of the unit (within
range of the device (4-7 meters)). The Receiver can be fixed to the surface by using the
double side tape pad.
Step 2: Install the small Emitters onto your controlled components,
using the following procedure: Remove the paper backing from
one of the Emitters, exposing the adhesive surface. Apply the
Emitter directly onto the centre of the sensor "window" on one of
Version 1.0 - 8-1-2013 4 ebode IR Link M