N'DUSTRIO 190TP0 Manuel D'utilisation Et D'installation page 60

REPLACING THE PLATE BURNER PILOT LIGHT NOZZLE
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panel (B).
4 - Unscrew the union (D).
5 - Remove the nozzle (E) and replace it with the
one suitable for the type of gas in use (see table
at back of manual).
6 - Retighten the union (D).
7 - Replace the control panel (B) and the knobs (A)
on completion of the operation.
REPLACING THE TOP BURNER PILOT LIGHT NOZZLE
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the con-
trol panel (B).
4 - Remove the pipe (D).
5 - Remove the nozzle (E) and replace it with the
one suitable for the type of gas in use (see table
at back of manual).
6 - Replace the pipe (D), the control panel (B) and
the control knobs (A).
IT
GB
DE
REPLACING OVEN BURNER PILOT LIGHT NOZZLE
FR
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
ES
2 - Access the pilot light through the opening pro-
vided in the bottom of the appliance.
3 - Unscrew the cap (B).
4 - Remove the nozzle (C) and replace it with the
one suitable for the type of gas in use (see table
at back of manual).
5 - Replace the cap (B).
English
A
C
B
A
C
B
- 28 -
C
IDM-39614802200.tif
D E
C
10
IDM-39614802300.tif
C
B
IDM-39614602900.tif
E
D