N'DUSTRIO 190TP0 Manuel D'utilisation Et D'installation page 46

To carry out this operation, proceed as follows.
1 - Remove the burner cap (A) and the burner (B).
2 - Clean the burner and the flame cap thoroughly
and check that the holes in it are not blocked.
3 - Clean the ignition slot in the burner regularly.
4 - Clean the hob.
5 - After use, clean the accessories with a suitable
grease-remover product. If possible, wash in
the dishwasher.
6 - Dry the surfaces and reassemble the compo-
nents. For correct burner assembly, follow the
instructions shown in the figure.
Caution - warning
Never pour water or allow dirt to fall into the
burner as this will cause the burner to mal-
function or block the nozzle.
To carry out this operation, proceed as follows.
1 - Remove the bottom plate (C) and the grid (D)
IT
IT
from the oven and clean them thoroughly.
2 - Clean the inside parts of the oven to remove
GB GB
any deposits which may impair its operation.
3 - Dry the surfaces and reassemble the compo-
DE DE
nents.
FR FR
ES
ES
English
CLEANING THE HOB, BURNERS AND ACCESSORIES
CLEANING OVEN
D
C
- 14 -
A
B
IDM-39614801100.tif
IDM-39614801200.tif