Electrical Connection - N'DUSTRIO 190TP0 Manuel D'utilisation Et D'installation

ELECTRICAL CONNECTION

Important
The connection must be made by author-
ised, skilled personnel, in accordance with
the relevant legal requirements, using ap-
propriate and specified materials. The ap-
pliance is supplied with operating voltage
230V/1N.
Caution - warning
Before doing any work, cut off the mains elec-
tricity supply.
A
5 - Undo the screws (G) to remove the lid (H).
6 - Connect the circuit-breaker (A) to the terminal
board (L) of the appliance as shown in the dia-
gram and in the electrical system diagram at
the back of the manual.
Use a flexible cable with at least type H07RN-F
characteristics, rated for an operating tempera-
ture of at least 80°C.
7 - Tighten the cable gland (M).
Important
When connecting, take care over the con-
nection of the neutral and earth wires; if
they are not connected correctly, the burn-
er does not light.
8 - Replace the lid (H), the electrical equipment
box (F) and the control panel (D) on completion
of the operation.
Connect the appliance to the mains electricity sup-
ply as follows.
1 - If not already present, install a circuit-breaker
(A) with overload cutout and differential safety
breaker close to the appliance.
2 - Pull off the knob (B).
3 - Undo the screws (C) and remove the control
panel (D).
4 - Undo the screws (E) to remove the electrical
equipment box (F). The position of the electric
equipment box varies depending on the ver-
sion. See connection diagrams at back of man-
ual for the correct position.
F
C
D
B C
G
- 21 -
F
E
E
M
IDM-39614601600.tif
IT
GB
G
DE
H
FR
L
ES
IDM-39614603700.tif IDM-3960200250.tif
English