N'DUSTRIO 190TP0 Manuel D'utilisation Et D'installation page 57

ADJUSTING OVEN BURNER PRIMARY AIR
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Undo the screws (B) and remove the control
panel (A).
3 - Undo the locking screw (C).
4 - Set the bush (D) in contact at the distance
shown in the figure.
5 - Tighten the screw (C).
6 - Replace the control panel (A) on completion of
the operation.
ADJUSTING TOP BURNER PRIMARY AIR (7 KW)
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panel (B).
4 - Remove the screw (D).
5 - Set the burner mount (E) at a distance of
20 mm, and tighten the screw (D).
6 - Replace the control panel (B) and the knobs (A)
on completion of the operation.
ADJUSTING TOP BURNER PRIMARY AIR (10 KW)
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panel (B).
4 - Remove the screw (D).
5 - Set the burner mount (E) at a distance of
20 mm, and tighten the screw (D).
6 - Replace the control panel (B) and the knobs (A)
on completion of the operation.
A
A
C
B
A
C
B
- 25 -
D
B
IDM-39614803000.tif
E
C
IDM-39614801700.tif
E
C
IDM-39614801800.tif
C
D
IT
GB
DE
FR
ES
D
English