Installation; Electrical Cord; Unpacking; Remove The Transport Supports - Electrolux ERC38810 Notice D'utilisation

INSTALLATION

Electrical cord

Do not remove the power cord by
pulling on its lead, particulary when the
product is being pulled out of its niche.
· Damage to the cord may cause a
short-circuit, fire and/or electric shock.
· In the event of damage to the
appliance's main cable, only an
authorised service company
recommended by the manufacturer or
a similarly qualified person may adjust
it in order to avoid shock hazard for the
user.

Unpacking

Unpack the cabinet and check that it
is in good condition and free of any
transport damage. Notify the dealer
immediately of any damage. Hand the
packaging over for recycling. For more
information, contact your local council
or the dealer.
Do not allow children to play with the
packaging. The plastic film can cause
suffocation.

Remove the transport supports

Remove the tape and the transport
supports from
· the door sides
· the shelves
Remove the transport support on the
glass shelf by pushing the support
forward along the edge of the shelf
until it stops. Take hold of the rear
edge of the glass shelf and pull the
shelf and transport support forward
until the shelf tilts and the transport
support can be removed.
Mounting the handle
The handle is included in the
packaging material of the cabinet.
Secure the handle.

Cleaning

Wash the inside of the cabinet using
lukewarm water, a mild washing-up
detergent and a soft cloth. Clean off
the interior wooden details with a moist
rag and mild kitchen soap. Do not
soak the wood.

Electrical connection

Connect the cabinet to a grounded
electrical outlet.
Voltage: 230 V.
Fuse: 10 A.
Refer to the rating plate on the left
inside the cabinet.
14