LEXIBOOK Move Cam Mode D'emploi page 32

32
DJA100IM1363_6Sept_V06.indb 32
HELMET MOUNT (Assembly)
27
28
Helmet Mount with Strap
1. Insert your camera in the waterproof case (18) or in the non-
waterproof mount also provided.
2. Fasten the camera in its case to the helmet mount (19) in the
place where the attachment screw (25) is located. Firmly screw
it in to ensure effective fastening.
3. You can adjust the camera's angle by unscrewing and then
carefully fitting the removable part where the camera (26) is
located. Ensure that this part is firmly screwed in again in order
to ensure effective fastening.
4. Connect the strap (27) to the two ends of the helmet mount.
5. Position the strap around the helmet or any other stand of
your choice, and then tighten its ends until it is firmly attached.
Strapless Helmet Mount
1. Follow the first 3 steps described above. You may also follow
all 5 steps above if you wish to attach the camera both with its
strap and with its adhesive fastener (recommended).
2. Next glue one side of the adhesive fastener (25) to the back
of the helmet mount (19) while you glue the other side to your
helmet or any other stand that you wish to use.
Remark: We recommend that you not only use the adhesive
fastener to attach the camera when engaging in extreme sports.
Combine the adhesive fastener with the strap provided, or
purchase a more durable adhesive fastener for such activities.
Note: The waterproof case must be properly closed again and it
is only waterproof to a depth of 10 metres.
18
25
19
26
We, Lexib
2, avenue
91953 Co
Declare u
Kind of pr
Type desi
Is in comp
EN 60950
EN 300 32
EN 301 48
EN 301 48
EN 62479
We hereb
complianc
European
Yiu Wai M
Product D
09/08/201
06/09/2013 5:38 PM