LEXIBOOK Move Cam Mode D'emploi page 31

BICYCLE MOUNT (Assembly)
VISION
cable
21
ble (sold
e.
paque
m your
19
22
23
24
1. Unscrew the screw (22) from the yoke joint.
ack mode
2. Position the yoke joint (21) and its rubber pad around the
bicycle handlebars and tighten the screw (22) until it is firmly
attached. Ensure that this part is firmly screwed in again in order
to ensure effective fastening.
3. To use the waterproof case, insert the camera in the
20(60fps)]/
waterproof case (19), and then re-close it using its latch,
ensuring that the latch is fully re-closed.
4. Position the waterproof case on the bicycle mount's (23)
attachment screw and screw in the case until it is firmly
attached.
5. To adjust the camera's position, loosen the screw (24) and
move the camera up or down, and then screw the screw in again
once the camera has been adjusted to the desired position.
Ensure that this part is firmly screwed in again in order to ensure
uor H
effective fastening.
Note: the waterproof case must be properly closed again and it
is only waterproof to a depth of 10 metres.
31
DJA100IM1363_6Sept_V06.indb 31 06/09/2013 5:38 PM