Jenn-Air JUD278DBCX00 Guide D'installation page 9

6. Be sure that the overlay panels are flush with the bottom of
the drawer fronts.
Top Drawer
A
B
A. Overlay panel
B. Drawer front
7. Repeat the process for the other drawer front.
8. Using a Phillips screwdriver, reinstall the wiring plug cover
(upper drawer).
Reinstall the Gaskets
1. Starting at the corners, and working toward the opposite
corner, press the gasket back into the groove. Be sure to seat
the gasket on all four sides.
2. Repeat the process for the other drawer.
Install the Wire Baskets
Reinstall the wire baskets. See "Remove the Wire Baskets,"
earlier in this section.
Install the Mounting Brackets
IMPORTANT:
Install two mounting brackets (upper and lower) on both sides
of the refrigerator drawers cabinet. The mounting brackets
secure the appliance to the adjacent cabinets.
To avoid the appliance pulling out of the opening when the
drawers are opened, secure the mounting brackets to the
adjacent cabinets.
The mounting bracket has an offset. Be sure when installing
the mounting brackets to position the offset to the adjacent
cabinets.
Bottom Drawer
A
B
1. Begin installation (on each side) at the pre-drilled holes for the
upper mounting brackets.
NOTE: Insulation tape covers the top pre-drilled holes for the
upper mounting brackets. Do not remove the insulation tape
when installing the upper mounting brackets.
A
B
A. Pre-drilled top hole is
underneath the insulation tape
B. Pre-drilled holes
2. Using a Phillips screwdriver and one #8 x ¹⁄₂" pan-head
screw, drive the screw through the bottom hole of upper
mounting bracket and into the pre-drilled hole. Tighten the
screw.
3. Push a pan-head screw through the insulation tape and into
the pre-drilled hole. Tighten the screw.
4. Using a Phillips screwdriver and two #8 x ¹⁄₂" pan-head
screws, drive the screws through the holes in the lower
mounting bracket into the pre-drilled holes. Tighten the
screws.
5. Repeat the process for the other side.
6. Set aside the remaining eight #8 x ¹⁄₂" pan-head screws for
later use. See "Attach the Mounting Brackets to Adjacent
Cabinets."
9