Dometic RM5310 Notice D'utilisation page 26

Troubleshooting
Displayed faults and signal tone (RM5385 only)
Faults are indicated by the flashing of individual buttons on the control panel,
a beep or a combination of both.
Display
and flashing,
a beep is emitted for
20 seconds
and flashing,
a beep is emitted for
20 seconds
and flashing,
a beep is emitted for
20 seconds
flashes
and flashing,
a beep is emitted for
20 seconds
and flashing,
a beep is emitted for
20 seconds
and flashing,
a beep is emitted for
20 seconds
Beep is emitted for
15 seconds at intervals
of two minutes
26
Problem
The AC heating
element is defective.
The DC heating
element is defective.
The burner or the
cooling unit is
defective.
The temperature
sensor has no contact
or is defective.
The power supply
is not available or
insufficient.
The power supply
is not available or
insufficient.
The burner flame is
not ignited.
The interior light is
switched on.
RM5310 – RM5385
Suggested remedy
Contact the authorised
customer service.
Check the AC power cable, the
power supply and the fuse.
Check the DC power cable, the
vehicle battery and the fuse.
Check the D+ signal on the
vehicle.
Check the gas supply (gas
cylinder, gas valve).
Press the button once the
fault is rectified.
Check whether the refrigerator
door is properly closed.
Close the refrigerator door.
EN