Cleaning & Storage - DS Produkte SC3108 Mode D'emploi

Nail attachment
1. Place the attachment onto the basic device as described.
2. When fi ling your nails, place the fi ling and grinding attachments onto the device
so that the locking lug on the attachment is seated in the provided recess in
the nail attachment. If the attachment is not in the right position, it will not move
when the device is switched on.
3. For manicures and pedicures use the attachments in the following sequence:
– Step 1 – Filing: Use the silver attachment and place the device directly onto
the nail edge.
– Step 2 – Grinding: Use the dark grey attachment and, with the device at a 45°
angle, guide it over the entire nail.
– Step 3 – Filling ridges: Use the green attachment and, with the device at a
45° angle, guide it over the entire nail.
– Step 4 – Polishing: Use the light grey attachment and, with the device at a
45° angle, guide it over the entire nail.
Cleaning & Storage
CAUTION!
❐ Do not use any pointed or sharp objects for cleaning!
❐ Caution: Danger of injury! Do not reach into the unprotected blades. If neces-
sary, use a soft brush or a suitable cleaning brush.
❐ Caution! This device is an electrical device. Never immerse the basic device
in water and do not rinse it off under running water so that it does not become
damaged!
❐ Do not use any caustic or abrasive agents to clean the device.
❐ No liquid must be allowed to enter the basic device during cleaning.
• Switch off the device and remove the batteries.
• Remove the attachment from the basic device.
• Wipe down the basic device with a damp cloth if necessary. Dry thoroughly
after rinsing.
Razor attachment for body hair
1. Press the buttons to the left and right of the attachment and the shaver head
will release the attachment. Remove it.
2. Carefully clean the shaver head and the attachment under running water.
3. Allow everything to dry completely before assembling the device again.
Razor attachment for the face
1. Pull the trimmer used off the attachment.
2. The attachment can be disassembled to clean it thoroughly. To do so, push the
catch down and pull off the loosened half with the blades slightly to the side
and up.
3. Carefully clean the trimmer and the attachment under running water.
18