Use - DS Produkte SC3108 Mode D'emploi

Use

CAUTION!
❐ Caution! This device is an electrical device. Make sure that it does not get wet
so that it does not become damaged.
❐ Do not use the device on irritated or broken skin. Test the trimmer or razor fi rst
on your arm or leg. If any skin irritations occur, do not use it!
• Do not use excessive pressure. You could injure yourself or damage
the trimmer!
3. Switch on the device by moving the On/Off switch to position 1 .
4. Hold the blade at an angle of 45° to the area to be shaved and guide it counter
to the direction of hair growth when using the body and facial hair razor
attachments as well as the hair trimmer.
5. To switch it off, push the switch back to its starting position 0..
6. After use, remove the attachment and clean the device and the attachment
used (see the "Cleaning and Storage" chapter).
Facial hair razor attachment
1. Place the attachment onto the basic device as described.
2. Depending on where it is to be used, select one of the trimmers (2 / 4 mm) and
place it on the attachment.
3. When trimming, smooth down the skin to obtain the cleanest possible result.
Hair trimmer
1. Place the hair trimmer onto the basic device as described.
2. Place the attachment for the hair trimmer onto the device so that
A B
3. Depending on the length of hair required, three different comb
4. When trimming, smooth down the skin to obtain the cleanest
1. Attach the required attachment onto the shaver
head so that the marking on the attachment is
above the right marking on the rear of the basic
device.
2. Turn the attachment in the direction of the arrow
until the attachment engages audibly. The mark-
ing of the attachment is now over the left marking
of the basic device.
the locking lug (A) fi ts in the provided recess and the comb is
seated over the razor blade at the same time.
heights (3.5 / 5.5 / 7.5 mm) can be set with the attachment. To do
this, press the comb up or down using the height adjuster (B).
possible result.
17