Cleaning The Device - DS Produkte Z 07259 Mode D'emploi

make sure that you use the correct side to avoid cutting
your eye brows too short!
3. Turn the hair trimmer on by moving the On/Off switch to the
ON position.
4. Run or "comb" your eye brows with the trimmer adapter to
trim them.
5. After use, turn the hair trimmer off by moving the On/Off
switch to the OFF position.
6. Take the eye brow trimmer adapter off by pulling it off of the
trimming head.
7. Every time after using the device, clean the hair trimmer
(see chapter "Cleaning the device") and put the protective
cap on the trimming head once you are fi nished using it.

Cleaning the device

ATTENTION!
• Never submerge the hair trimmer in water or other liquids!
• Make sure that the battery compartment of the shaver is
closed correctly when cleaning it under running water!
• Only use the shaver if the correct shaving foil has been in-
serted!
• Do not use corrosive or abrasive cleaning products to clean
the shaver/trimmer! They could damage the surface.
Shaver
• Use the enclosed cleaning brush to brush off the shaver
head or rinse it under clean running water.
25 GB