DS Produkte Z 07259 Mode D'emploi page 26

GB
• Clean the integrated trimmer by brushing it off or rinsing it
off under clean, running water.
• Always allow all parts to air dry completely before putting
the shaver back together!
Changing the shaving foil
A spare shaving foil is included in the product contents!
If the shaving foil is worn, change it:
• Put the shaver head with the shaving foil inserted back on
the shaver!
26
• To remove the shaver head,
push the two release buttons on
the side of the shaver head and
pull it up and off of the device.
Clean the blades under the shav-
er head by brushing them off or
rinsing them off under clean, run-
ning water.
• Take the shaver head off by
pushing the two release buttons
on the side of the shaver head
and pulling the shaver head up
and off.
• Take the worn shaving foil out of
the shaver head and insert the
new shaving foil.
Make
shaving foil is properly
seated in the shaver head
and that it cannot slip out!
sure that the