DS Produkte Z 07259 Mode D'emploi page 24

GB
3. Start shaving by running the shaver head over your skin. Do
not apply too much pressure!
4. If you would like to use the integrated trimmer on the back,
simply slide it up in the direction of the arrow. If you no
longer wish to use it, push it back into the initial position.
5. After use, switch the shaver off by holding the safety button
on the On/Off switch down and at the same time pushing
the switch down.
6. Every time after using the device, clean the shaver (see
chapter "Cleaning the device") and put the protective cap
on the shaver head once you are fi nished using it.
Hair trimmer
1. Remove the protective cover.
2. Turn on the hair trimmer by pushing the On/Off switch to the
ON position.
3. Let the trimming head glide over the area you would like to
trim. Do not apply too much pressure.
4. Once you are done using it, switch the hair trimmer off by
moving the On/Off switch to the OFF position.
5. Every time after using the device, clean the hair trimmer
(see chapter "Cleaning the device") and put the protective
cap on the trimming head once you are fi nished using it.
Eye brow trimmer adapter
The eye brow trimmer adapter is mounted on the hair
trimmer!
1. Ensure that the hair trimmer has been switched off.
2. Push the eye brow trimmer adapter onto the trimming head
until it audibly locks into place. Please note: the adapter
has two sides – a long one and a short one. Always
24