Unify OpenStage 20 Guide Rapide D'installation Et De Référence page 9

Masquer les pouces Voir aussi pour OpenStage 20:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
Installing the Cables at the SIP/HFA Phone
Check the appendix for a compatible phone.
1. Insert the LAN cable into the jack
2. If your LAN does not have PoE (Power over Ethernet; ask your service personnel), then you
need to use a power supply.
Insert the power supply plug into the jack
To prevent damage to the unit, it is imperative that you observe the following:
The power supply may only be plugged into the
3. All other jacks are optional:
: LAN connection to PC.
: Connection to Headset
: Connection to KeyModule, Busy Lamp Field
: USB master, e.g. for a USB memory stick
To prevent damage to the unit, it is imperative that you observe the following:
If an USB memory stick should be connected to the USB interface, an adaptor cable (or-
der no.: C39195-Z7704-A5) has to be used.
The unit is now ready for operation.
If further settings are required for correct operation of the telephone, contact your service per-
sonnel.
Installing the Cables at the TDM Phone
Check the appendix for a compatible phone.
1. OpenStage 20/40 T: 
Insert the U
cable into the jack
P0/E
OpenStage 40 T with Key Module, OpenStage 60/80 T:
Insert the U
cable into the jack on the power supply and connect the other jack on the
P0/E
power supply with jack
To prevent damage to the unit, it is imperative that you observe the following:
The power supply may only be plugged into the
2. All other jacks are optional:
: Connection to Headset
: Connection to KeyModule, Busy Lamp Field
(left): USB slave for connection to the PC ("1st party CTI")
(right): USB master, e.g. for a USB memory stick
To prevent damage to the unit, it is imperative that you observe the following:
If an USB memory stick should be connected to the USB interface, an adaptor cable (or-
der no.: C39195-Z7704-A5) has to be used.
The unit is now ready for operation.
If further settings are required for correct operation of the telephone, contact your service per-
sonnel.
1.
Not OpenStage 20 E/20
2.
OpenStage 60 only
3.
Not OpenStage 20 T
4.
OpenStage 60/80 T only
on the base of the telephone.
on the base of the telephone.
1
.
2
on the base of the telephone.
on the base of the telephone.
3
.
jack.
[1]
.
.
jack.
[3]
.
[3]
.
4
.
Installation
9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Openstage 40Openstage 60Openstage 80

Table des Matières