Dehumidification - Siemens S1 RKM 09012 Mode D'emploi

Permanent installation

Dehumidification

The appliance can be installed on a permanent
basis using window/wall Optional Accessory,
reference S1 RKZ 06009, available from your
supplier.
A hole must be made in the wall and the wall
accessory fitted in order to expel hot air.
Store the diffusion duct away and connect the air
expulsion duct to the accessory.
Only the transparent end section of the
accessory is used when air is to be expelled
through a window on a permanent basis. A
10.5-cm. diameter hole must be made in the
glass in order to fit the accessory.
N.B.
• Do not extend the hot-air expulsion duct more
than necessary (maximum length: 140 cm.).
• There must be a distance of at least 70 cm.
between the floor and the end of the duct.
• Do not bend the duct too sharply when
positioning it.
This can impede proper hot-air expulsion, which
may reduce cooling efficiency.
When set to , the appliance removes humidity
from the atmosphere. It does not, however, control
the temperature.
Turn drainage stopcock 90° in an anti-clockwise
direction.
Remove stopcock plug and insert drainage pipe.
stored in the main filter compartment.
Place a bowl at the drainage pipe outlet to collect
the condensed water in.
Put the air extraction duct in storage position.
Set control knob to dehumidification position
Fig. 8, by pressing the "mode" button.
The amount of water removed from the air can
reach as much as 30 liters/24 hours, depending
on atmospheric conditions
,
31