Power-On Options - Beha-Amprobe Telaris Série Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 68
Over-temp
Fault Voltage
Excessive Probe
Resistance

Power-On Options

To select a power-on option, press
the
button. Power-on options are retained when the tester is turned OFF. See Table
below.
UK - Mode Selected
Keys
Power-on Options
Line and Neutral Swap mode. Two modes of operation are available. You
can configure the tester to operate in L-n mode or L-n n-L mode, see Figure
7.
• In L-n mode, the L and N phase conductors must NEVER be reversed. This
is a requirement in some regions including the UK. The
on the display indicating that the system L and N conductors are swapped
and testing is inhibited. Investigate and rectify the cause of this system
fault before proceeding. L-n mode also changes the RCD x1/2 trip time
duration to 2 seconds as required in the UK.
• In L-n n-L mode, the unit allows the L and N phase conductors to be
swapped and testing will continue.
Note: In locations where polarized plugs and outlets are used, a swapped
lead icon (
this problem before proceeding with any testing.
Fault voltage limit. Toggles the fault voltage between 25 V and 50 V. The
default is 50 V.
View the tester serial number. Primary display shows the initial four digits
and the secondary display shows the next four digits.
Continuity beeper toggle. Toggles the continuity beeper on and off. The
default is on.
2
Wait while the tester cools down.
Check the installation, in particular, the voltage
4
between N and PE.
Put the stakes deeper into the soil. Tamp down the soil
6
directly around the stakes. Pour water around the stakes
but not at the earth ground under test.
and the function key simultaneously and then release
Figure 7. Lead Swapping Modes
) may indicate that the outlet was wired incorrectly. Correct
Automatic Lead
Swapping Mode Selected
9
icon appears

Publicité

Table des Matières
loading

Table des Matières