akkuteam VAS 5900 Instructions De Service page 27

Retrieving para- Press the Info button several times in a row to display the parameters in the
meters during following sequence:
charging
Example: current battery
voltage
Interrupting Press Start/Stop button to interrupt charging:
charging
In the case of deep-discharge batteries (voltage < 2 V), charging must be started manu-
Charging deep-
discharge batte- ally as follows:
ries
1.
2.
3.
4.
5.
6.
7.
8.
9.
Example: current charging
current
-
-
WARNING! Risk of serious damage as the result of
- incorrectly connected charging terminals. The terminal polarity reversal
facility is inoperative in „Charging deep-discharge batteries back-up"
mode.
- incorrectly set battery voltage.
Connect charging terminals to correct poles and ensure proper electrical
connection to vehicle terminals. Note battery voltage.
CAUTION! Risk of damage when attempting to charge a faulty battery. Before
charging, ensure that the battery to be charged is fully functional.
Plug in charger mains plug
Set mode
Set battery capacity
Connect the battery
Press and hold Start/Stop button for approx. 5 sec. - „Charging deep-discharge
batteries/back-up mode" menu item is activated
Select battery voltage by pressing Up/Down buttons
Example: 12 V vehicle voltage
Confirm selected voltage by pressing Start/Stop button
Confirm correct terminal connection prompt by pressing Start/Stop button
Charging begins
Example: ampere-hours
already charged
The display shows the number of ampere-hours already
charged
Press Start/Stop button again to resume charging
If no buttons are pressed within 5 seconds, the charger
returns to the main menu.
5