Zanussi ZBA30455SA Notice D'utilisation page 27

x
x
3. Push the appliance in the direction of the
arrows (1) until the upper gap cover stops
against the kitchen furniture.
4. Push the appliance in the direction of the
arrows (2) against the cupboard on the
opposite side of the hinge.
5. Make sure that the distance between the
appliance and the cupboard front-edge is
44 mm.
6. The lower hinge cover (in the accessories
bag) makes sure that the distance between
the appliance and the kitchen furniture is
correct.
7. Make sure that the clearance between the
appliance and the cupboard is 4 mm.
8. Open the door. Put the lower hinge cover in
position.
2
1
9. Attach the appliance to the niche with 4
screws.
10. Remove the correct part from the hinge
cover (E). Make sure to remove the part DX,
in the case of right hinge, SX in opposite
case.
I
I
11. Attach the covers (C, D) to the lugs and the
hinge holes.
12. Install the vent grille (B), attach the hinge
covers (E) to the hinge.
www.zanussi.com
13mm
Ø 2,5
4mm
44mm
13. Disconnect the parts (Ha), (Hb), (Hc) and
(Hd).
C
D
E
E
B
14. Install the part (Ha) on the inner side of the
kitchen furniture.
15. Push the part (Hc) on the part (Ha).
50 mm
90°
21 mm
21 mm
50 mm
16. Open the appliance door and the kitchen
furniture door at an angle of 90°.
17. Insert the small square (Hb) into guide (Ha).
18. Put together the appliance door and the
furniture door and mark the holes.
19. Place the small square on the guide again
and fix it with the screws supplied.
20. Align the kitchen furniture door and the
appliance door by adjusting the part Hb.
8 mm
Hb
Ha
21. Press the part (Hd) on the part (Hb).
Hb
Hd
Do a final check to make sure that:
• All screws are tightened.
Ha Hb
Hc Hd
Ha
Hc
Hb
27