The device can be configured using the web interface. After configuring the network parameters
using the front panel and connecting to the local network, or to a PC using a LAN cable, the web
browser can be used (Chrome is recommended) by entering the unit IP address.
ESEMPIO DI CONFIGURAZIONE DIRETTA CON PC:
Change the IP address of
one set in the local net card on the PC. Then the "authentication window" will appear:
Parameters set in the PC network card:
•IP ADDRESS :
192.198.1.2
•SUBNET MASK: 255.255.255.0
•GATEWAY:
192.168.1.1
Factory parameters in the network settings of D-MATRIX-4S FTA:
•IP ADDRESS : 192.168.1.100
•SUBNET MASK: 255.255.255.0
•GATEWAY:
192.168.1.1
- USER NAME : admin
- PASSWORD : 1234
By confirming with ENTER, the STATUS page will
appear, from which it will be possible to access
all the programming of the D-Matrix-4S FTA.
Status page of D-MATRIX 4S-FTA
PROGRAMMING BY WEB INTERFACE
D-MATRIX-4S FTA
using a value that belongs to the same subnet as the
Authentication window with FACTORY PARAMETERS
Access
Username
admin
admin
1234
13