Nilfisk ALTO SCRUBTEC R 253 Instructions D'utilisation page 69

5. Adjust the solution flow by pressing the push-button (44) as necessary, depending on the type of cleaning to be performed.
NOTE
For the first 3 flow levels (Fig. 4), the amount of solution dispensed is automatically adjusted according to the machine
speed, in order to obtain a constant amount of solution per linear meter of cleaning.
Level 4 (when enabled) supplies the maximum possible quantity of detergent solution, regardless of the machine speed
(to enable or disable this, see the Super User key section in the Maintenance chapter).
The level 0 closes the solution flow completely.
Lev.
1
0,75 cl/m
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Nilfisk Alto suggests to go near the walls with the right side
of the machine as shown in figure 5.
A
6. To stop scrubbing/drying, press the push-button (42) and wait for the brush deck (7) to lift. After 10 seconds, the vacuum
system turns off too and the squeegee (13) lifts.
1/15
Lev.
3
Lev.
2
1,5 cl/m 3,0 cl/m
Figure 4
Figure 5
INSTRUCTIONS FOR USE
Lev.
4
2,8 l/min
B
9100000391 - SCRUBTEC R 253
ENGLISH
Lev.
0
OFF
P100866
P100867
15