Connections; When Using Usb Bus Power; When Using The Usb/Ac Adaptor; When Using Batteries - Yamaha NX-U10 Mode D'emploi

Use the procedure below to choose one of the three power supplies according to your usage circumstances.
1
When using USB bus power (this page)
2
When using the USB/AC adaptor (page 4)
3
When using batteries (page 5)
Notes
• Before connecting, make sure that POWER switch on this unit is turned off.
• Before connecting, make sure that VOLUME dial on this unit is set to the minimum.
1

When using USB bus power

When you connect the USB port for the first time, you need to download USB drivers into your computer. For the procedure
of the installing USB drivers, see "Installation of USB drivers" on page 3.
1
1
Press and hold the concave portion on the
stand and open it upward.
2
Connect the small plug of the supplied USB
cable to the USB jack of this unit.
3
Connect the large plug of the USB cable to
the USB port of your computer.
Note
Never connect your computer via an USB hub. This unit may
not work properly.
4
Put this unit on a flat surface (a desk etc.)
using the stand.
Note
When setting up this unit, do not apply force to the top of this
unit. Doing so may cause damage or break the stand.
2
En

CONNECTIONS

Concave portion
2
USB cable (small plug)
The supplied USB Cable
Computer
3
(Large plug)
Enjoying sounds of a portable audio
player using the USB bus power
You can also enjoy the sound of a portable audio player
using a computer as power source when you connect a
portable audio player to the PORTABLE jack of this
unit using the supplied 3.5 mm stereo mini plug cable.
Note
In this case, the sound output from this unit is mixed with the
sound from your computer. Adjust the mixing level using
volumes of your computer's media player or your portable
audio player.
4
3.5 mm stereo mini plug cable