GreenWorks Tools 3802507 Manuel D'utilisation page 3

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
SDS Plus Chuck
The SDS chuck 2 allows quick insertion and release of
SDS and SDS Plus bits.
Mode Selector
The mode selector 9 allows you to quickly switch from
rotary mode to hammer mode.
ASSEMBLY
Unpacking
This product requires assembly.
■ Carefully remove the product and any accessories
from the box. Make sure that all items listed in the
packing list are included.
Do not use this product if any parts on the Packing
List are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.
■ Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
■ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of this
product with damaged or missing parts could result in
serious personal injury.
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
To prevent accidental starting that could cause
serious personal injury, always remove the battery
pack from the product when assembling parts.
Battery Charging
■ Use only the chargers listed in the technical data. Only
these chargers are matched to the lithium-ion battery
of your power tool.
NOTE: The battery supplied is partially charged. To
ensure full capacity of the battery, completely charge the
battery in the battery charger before using your power tool
for the first time.
English (Original Instructions)
WARNING
WARNING
WARNING
WARNING
The lithium-ion battery can be charged at any time
without reducing its service life. Interrupting the charging
procedure does not damage the battery.
The lithium-ion battery is protected against deep
discharging by the "Electronic Cell Protection (ECP)".
When the battery is empty, the machine is switched off by
means of a protective circuit: The inserted tool no longer
rotates.
■ Do not continue to press the On/Off switch after the
machine has been automatically switched off. The
battery can be damaged.
Observe the notes for disposal.
OPERATION
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
Always wear eye protection with side shields marked
to comply with ANSI Z87.1 along with hearing
protection. Failure to do so could result in objects
being thrown into your eyes and other possible
serious injuries.
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury.
Removing the battery (see figure A)
To remove the battery 7, press the battery unlocking
button 8 and pull the battery out of the power tool toward
the rear. Do not exert any force.
Switch Trigger (see figure B)
To turn the drill ON, depress the switch trigger. To turn it
OFF, release the switch trigger.
Direction Of Rotation Selector (see figure C - D)
(Forward/Reverse/Center Lock)
The direction of bit rotation is reversible and is controlled
by a selector located above the switch trigger. With the
drill held in normal operating position, the direction of
rotation selector should be positioned to the left of the
switch trigger for drilling. The drilling direction is reversed
when the selector is to the right of the switch trigger.
Setting the direction of rotation selector in the OFF (center
lock) position helps reduce the possibility of accidental
starting when not in use.
3
WARNING
WARNING
WARNING
CAUTION