Panasonic DVD-LX97 Manuel D'utilisation page 29

3
Attaching the unit to the bracket.
While holding the unit with both hands, line up the unit just below the protruding sections on the
bracket. Press the unit down about 4 to 5 mm
the holes on the bottom of the unit.
Please check the following points before use.
–The bracket is securely fastened to the unit.
–The unit is not loose and cannot be lifted upwards.
Line up the protruding
sections here.
Diagram of attached bracket
Depending on the type of headrest, you
may not be able to attach the bracket.
23 cm (9 1 / )
16
or less
( to ) so that the protrusions on the bracket fit into
5 / 3 /
32 16
When correctly
click!
attached,
you will hear a
locking sound.
Use the monitor in the open
position as shown in the
illustration to the right to
prevent abnormal audio or
damage resulting from
vibrations in the car.
The angle of the monitor can
be adjusted up to about 30°.
The angle of the monitor may shift
while driving due to vibration, etc.
Releasing the unit from the bracket
Release
button
Press the release buttons (left and right) in
towards the center of the bracket.
Lift the unit up to release it.
Do not press the release buttons any time other
than when detaching the unit from the bracket.
29
29